Tecumseh compressor serial number nomenclature

#Tecumseh compressor serial number nomenclature code
#Tecumseh compressor serial number nomenclature free

From what I know I will be needing a rebuild kit for the carb and either a rebuild kit for the fuel pump or a new fuel pump. HH160-1700E It is in a ARGO 6 wheel amphibious vehicle, I was able to make it run with some starting fluid after I took the starter off and repaired it. It has вЂњsolid stateвЂќ on the cover, I was able to get the following numbers off the top of the cover. Trying to get some information for a small engine, not really sure what brand it is. The engineвЂ™s base mounting plate (Tecumseh part #29538) dimensions (height, width, length) and bolt hole spacing. Whether the crankshaft is tapered, keyed, and/or threaded. Tecumseh Products Company has prepared this handbook to assist service personnel in safely working with refrigeration and air conditioning equipment that uses Tecumseh Products Company hermetic compressors.

#Tecumseh compressor serial number nomenclature free

For more free Tecumseh literature please visit. Not listed, contact Tecumseh Compressor Company. The breakdown of the serial number for a Bristol Reciprocating Compressor is: Digits 1-3: Julian Date of Manufacture Digits 3-4: Year Manufactured Digit 6: Mfg Location - 0 or 2 = Bristol Digits 7-11: Sequence # During Week For Bristol Stroll Compressors, See Scroll Technologies Compressors. The distance from the oil seal/coverвЂ™s mounting face to the end of the crankshaft. The distance from from the engine base to the crankshaft center line. I need the following information for the above engine: 1. Part #32680A I would like to re-engine my blower. Crankshaft is tapered, keyed, and threaded. H70-130168A 7 Horsepower, 15 cubic inches Tecumseh 120 Volt Electric Snow-blower Starter (motor) Kit, part #33328D. I have a Craftsman snow thrower as follows: Craftsman snow thrower, model number: 536-90510HC2 Craftsman engine, model no. I just bought a troy-bilt (pony) tiller at auction.the engine is bad and i need a replacement for it.the serial #is P78906 on the tiller.the engine is a 5hp brigs and stratten horizontal shaft with a extra long cam shaft to provide a reverse to the tiller.i have this engine taken apart.the only numbers i can find on the block is the # 13 inside the valve spring area and there is a letter M behind the flywheel/magneto.there is the lettering on the crank itself and that is QHS.THAT IS THE ONLY #rs on the block. True 842099 - AEA2380ZXA Compressor by Tecumseh.

This first section explains the Tecumseh Model, Spec, and Serial (D.O.M) numbers.

Below, I will explain what most of theses numbers mean and where they can be found. You cannot get parts for any engine or power equipment if you do not specify at least the model number.

#Tecumseh compressor serial number nomenclature code

Model, Type (Spec.) and Code (Serial or D.O.M) numbers are found on every single engine or O.P.E in the U.S.A. Model, Type (Spec.) and Code (Serial or D.O.M) numbers. The breakdown of the serial number is Digit 1: S for Scroll Technologies Digits 2-3: Week Manufactured Digits 4-5: Year Manufactured Digits 6: State (K for Arkansas) Digits 7-11: Sequence # During Week. In September 2006, Danfoss, a Danish company purchased Stroll Technologies from Carlyle and Bristol. Scroll Technologies Compressors Stroll Technologies was a joint venture between Carlyle Compressors (a division of Carrier) and Bristol Compressors, and the compressors were sold exclusively through these partners as the 'Millenium' for Carlye and the 'Infinity for Bristol.